No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Web Online Help

TE10 Videoconferencing Endpoint V600R019C00

This document describes the help information on the web interface.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Placing a Call

Placing a Call

You can place a call from your endpoint to start a conference.

Point-to-Point Conference

  1. Choose Conference > Call.
  2. Select remote sites you want to call using either of the following methods:
    • Click Call Logs and select the remote sites.
    • Enter the name, number, or IP address of each remote site.

    You can also place calls from the Address Book page. For details, see Placing a Call.

  3. Set the site parameters, listed in Table 4-1.

    Table 4-1  Site parameters




    Site name/IP address/Number

    Specifies the name, number, or IP address of the site you want to call.

    No default value is set for this parameter.

    Line type

    Specifies the type of the line used to place the call.

    By default, the last used line type is displayed.


    Specifies the data transmission rate required.

    The data transmission rates supported by your endpoint vary depending on the type of site you want to call.

    Select the highest available data transmission rate.


    If this parameter is set incorrectly, the video quality will be affected or the call might even fail to be set up.

    Call mode

    Specifies the call type.

    • Video: Place video calls
    • Voice: Place audio-only calls

    The default value is Video.

    Advanced Settings

    Specify advanced conference parameters. For the description of each advanced conference parameter, see Setting Advanced Conference Parameters.

  4. Click Call.

Multipoint Conference

  1. Choose Conference > Call.
  2. In the Site name/IP address/Number text box, enter conference access number, for example, 0755100000159. Click Call.
  3. Choose Conference > Second Dial. Then enter the conference password and press the pound button (#) as prompted.

    Obtain the conference access number and password from the SMC2.0 administrator. To join a conference that has a password, enter the password using the keypad.

Updated: 2019-12-02

Document ID: EDOC1100044672

Views: 14873

Downloads: 17

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next