No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage V100R006C30 Block Storage Service Disaster Recovery Feature Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating Block Storage Clients

Creating Block Storage Clients

Scenarios

Create block storage clients for all the DR nodes using commands.

Prerequisites

Conditions

FusionStorage Agent (FSA) nodes have been installed.

Procedure

    1. Use PuTTY to log in to the FusionStorage Manager (FSM) node.

      Ensure that username dsware and the management plane floating IP address are used to establish the connection. The default password of user dsware is IaaS@OS-CLOUD9!.

    2. Run the following command to switch to the specified directory:

      cd /opt/dsware/client/bin

    3. Run the following command to create block storage clients for all the DR nodes:

      NOTE:

      Since the system has been hardened, you need to enter the username and password for login authentication after running the dswareTool command of FusionStorage Block. The default username is cmdadmin, and its default password is IaaS@PORTAL-CLOUD9!.

      The system supports authentication using environment variables so that you do not need to repeatedly enter the username and password for authentication each time you run the dswareTool command. For details, see Authentication Using Environment Variables.

      sh dswareTool.sh --op createDSwareClient -ip ip1,ip2,ip3... -nodetype 1,1,1...

      In the command, ip1,ip2,ip3,.. specifies the IP addresses of DR nodes, and 1,1,1... specifies the leader/follower attribute switchover of block storage clients. Value 1 indicates that the block storage client cannot be elected as the leader block storage client. Values in this command must be set to 1, and the number of value 1 must be consistent with that of the DR node IP addresses.

Translation
Download
Updated: 2019-01-17

Document ID: EDOC1100044928

Views: 19318

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next