About This Document
This document describes basic concepts of the OceanStor BCManager eReplication software and how to install, configure, and manage this software.
Intended Audience
This document is intended for:
- Installation and Commissioning Engineer
- Data Configuration Engineer
- Network Monitoring Engineer
- System Maintenance Engineer
Symbol Conventions
The symbols that may be found in this document are defined as follows.
Symbol |
Description |
---|---|
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. |
|
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. |
|
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. |
|
Indicates a potentially hazardous situation which, if not avoided, could result in equipment damage, data loss, performance deterioration, or unanticipated results. NOTICE is used to address practices not related to personal injury. |
|
Calls attention to important information, best practices and tips. NOTE is used to address information not related to personal injury, equipment damage, and environment deterioration. |
Change History
Changes between document issues are cumulative. The latest document issue contains all the changes made in earlier issues.
Issue 02 (2018-12-21)
Revised Section |
What's New |
---|---|
Added the The Create DataStore Step Fails to Be Performed and Message If a storage device is used for the first time or its file system cannot be identified, the storage device can be added as a data store only after being formatted. Add the storage device as a data store again and set it to be formatted. After it is formatted, original data on it is erased Is Displayed When the Fault Recovery Step Is Performed fault case. |
|
Added the The Register VM Step Fails to Be Performed and Message Failed to register volumes and LUN that is required by the VM has not been mapped to the host, has become invalid or has not been managed by a consistent group Are Displayed When the Fault Recovery Step Is Performed fault case. |
|
Deleted the Refresh operation in this section. |
Issue 01 (2018-10-30)
This issue is the first official release.