No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_cdp_schedule enabled

change hyper_cdp_schedule enabled


The change hyper_cdp_schedule enabled command is used to enable or disable a HyperCDP schedule.


change hyper_cdp_schedule enabled schedule_id_list=? enabled=?






ID list of HyperCDP schedule IDs.

  • To obtain the value, run "show hyper_cdp_schedule general". The value is an integer from 1 to 512.
  • You can enable or disable multiple HyperCDP schedule IDs separated by commas (,) or an ID range using hyphens (-), such as: 1,5-8.


Whether to enable or disable a HyperCDP schedule.

The value can be:

  • "yes": enables a HyperCDP schedule.
  • "no": disables a HyperCDP schedule.



Usage Guidelines

Before performing the operation, confirm that the schedule ID is correct and exits.


  • Enable HyperCDP schedule "3".
    admin:/>change hyper_cdp_schedule enabled schedule_id_list=3 enabled=yes 
    Change HyperCDP schedule enabled 3 successfully.
  • Disable HyperCDP schedule "1".
    admin:/>change hyper_cdp_schedule enabled schedule_id_list=1 enabled=no 
    WARNING: You are about to stop HyperCDP schedule. After this operation, HyperCDP objects will no longer be created based on the schedule.  
    Suggestion: Before performing this operation, ensure that you do not need to create HyperCDP objects anymore. 
    Have you read warning message carefully?(y/n)y 
    Are you sure you really want to perform the operation?(y/n)y 
    Change HyperCDP schedule disabled 1 successfully.

System Response


Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 122324

Downloads: 151

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next