No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
remove hyper_copy_consistency_group hyper_copy

remove hyper_copy_consistency_group hyper_copy


The remove hyper_copy_consistency_group hyper_copy command is used to remove HyperCopy pairs from a specified HyperCopy consistency group. Use this command if consistency management is not required for HyperCopy pairs.


remove hyper_copy_consistency_group hyper_copy hyper_copy_consistency_group_id=? hyper_copy_id_list=?






ID of the HyperCopy consistency group whose members are to be removed.

To obtain the value, run "show hyper_copy_consistency_group general".


ID list of the HyperCopy pairs removed from a HyperCopy consistency group.

To obtain the value, run "show hyper_copy_consistency_group hyper_copy". If you want to remove multiple HyperCopy pairs from a HyperCopy consistency group, perform either of the following:

  • Separate multiple HyperCopy pair IDs by commas (,). For example, "hyper_copy_id_list=1,2,3,4,5".
  • Specify a HyperCopy pair ID range using a hyphen (-). For example, "hyper_copy_id_list=1-5,7,9-11".



Usage Guidelines



Remove HyperCopy pairs "2" and "3" from HyperCopy consistency group "1".

admin:/>remove hyper_copy_consistency_group hyper_copy hyper_copy_consistency_group_id=1 hyper_copy_id_list=2,3 
WARNING: You are about to remove HyperCopy pair  from the HyperCopy consistency group . After the removal, the HyperCopy pair is not protected by the HyperCopy consistency group. 
Suggestion: Before performing this operation, ensure that HyperCopy pair does not need HyperCopy consistency group protection. 
Have you read warning message carefully?(y/n)y 

Are you sure you really want to perform the operation?(y/n)y 
Remove HyperCopy 2 from HyperCopy consistency group successfully. 
Remove HyperCopy 3 from HyperCopy consistency group successfully.

System Response


Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 121554

Downloads: 149

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next