No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show system ntp

show system ntp


The show system ntp command is used to query the Network Time Protocol (NTP) settings.


show system ntp





Usage Guidelines

This command is invisible to adapt to the NTP authentication feature.


Query the NTP settings, run the following command. The command output varies depending on cli interface.

admin:/>show system ntp 

  NTP Switch             : Enable 
  Server IP Address      : 
  Synch Schedule         : 0 day(s),12 hour(s),0 minute(s),0 second(s)

System Response

The following table describes the parameter meanings.



NTP Switch

NTP synchronization switch(Default value:"disable").

Server IP Address

NTP server address.

Synch Schedule

NTP synchronization period(Default value:"60 seconds").

Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 123552

Downloads: 155

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next