No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show system dst

show system dst


The show system dst command is used to query the daylight saving time (DST) settings of the storage system.


show system dst continent=? capital=?






General area (continent or region) where the storage system resides.

The value can be "Africa", "America", "Antarctica", "Arctic", "Asia", "Atlantic", "Australia", "Etc", "Europe", "Indian", "Pacific", or "other".


Specific area (major city, province, or state) where the storage system resides.

The value varies depending on the continent=? parameter. Refer to the information displayed in the CLI.



Usage Guidelines

The storage system automatically sets the DST based on the configured time zone. The DST is not applicable to some time zones.


To query the DST settings of the storage system, run the following command. The command output varies depending on cli interface.

admin:/>show system dst continent=Europe capital=London 

  Time Zone       : Europe/London  
  Begin Time      : 03-26 01:00:00  
  End Time       : 10-29 02:00:00  
  Adjust Time(Minutes) : 60             
  Config Mode      : Date

System Response

The following table describes the parameter meanings.



Time Zone

Time zone name.

Begin Time

Start time of daylight saving time.

End Time

End time of daylight saving time.

Adjust Time(Minutes)

During the time of daylight saving time adjustment.

Config Mode

Configuration method of daylight saving time.

Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 121272

Downloads: 149

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next