No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show host_auto_scan

show host_auto_scan

Function

The show host_auto_scan command is used to check whether the automatic scan of a host is enabled.

Format

show host_auto_scan

Parameters

None

Level

Guest

Usage Guidelines

On the CLI, run the show host_auto_scan command to check whether the automatic scan function of the host is enabled.

Example

To check whether the automatic scan function of a host is enabled, run the following command:

admin:/>show host_auto_scan 

  Auto-Scan Switch 
  ---------------- 
  Off

System Response

The following table describes the parameter meanings.

Parameter

Meaning

Auto-Scan Switch

Indicates the switch of the automatic scan function.

Translation
Download
Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 116170

Downloads: 134

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next