No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change bond_port ipv4_address

change bond_port ipv4_address


The change bond_port ipv4_address command is used to change the IPv4 address of the bond port.


change bond_port ipv4_address bond_port_name=? ip=? mask=?






Bond port name.

To obtain the value, run the "show bond_port" command.


Bond port IPv4 address after the change.

The IPv4 address cannot start with 0 or an integer from 224 to 255.


IPv4 subnet mask of the bond port after the change.




Usage Guidelines

  • This operation disconnects the storage system and application server.
  • Before performing this operation, check whether a redundant connection exists. If it does not exist, first stop all the services on the application server.
  • Before performing this operation, ensure that the entered IP address is reachable.
  • The IP address of a host bond port cannot be at the same network segment as that of the management network port.


Set the IP address of bond port "bond_1_1" whose subnet mask is "" to "". The bond port name and command output vary depending on products. The name and output here are just examples.

admin:/>change bond_port ipv4_address bond_port_name=bond_1_1 ip= mask= 
DANGER: You are about to change the IP address of port. This operation will disconnect the storage system from hosts. This operation will also clear the configured routes on the IP address that is modified on this port. 
1. Check whether there are redundant connections to hosts. If there are no redundant connections, stop host services. 
2. Ensure that the entered IP address is available. 
Have you read danger alert message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 122566

Downloads: 151

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next