No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change dr_star disable

change dr_star disable


The change dr_star disable command is used to deactivate DR Star.


change dr_star disable dr_star_id=? [ is_local_execute=? ]






DR Star ID.

To obtain the value, run "show dr_star general".


Whether this command is executed at the local site.

The value can be "yes" or "no", where:

  • "yes": allows local execution.
  • "no": forbids local execution.

The default value is "no".



Usage Guidelines

  • This operation will damage the ring relationship of DR Star and its two remote replication members cannot be switched when a fault occurs.
  • Before performing complete deactivation, check whether the replication links between the primary site and the other two sites are normal.
  • Before performing local deactivation, ensure that at least one of the replication links between the local site and the other two sites is disconnected.
  • When the members of DR Star are consistency groups, execute this command to deactivate the DR Star before adding or removing a consistency group member.
  • DR Star cannot be deactivated if its running status is "Invalid".


Disable DR Star "200bc79b99520000".

admin:/>change dr_star disable dr_star_id=200bc79b99520000 
CAUTION: You are about to disable DR Star. This operation will change the running status of the DR Star to the disable state. 
Suggestion: Before performing this operation, check the running status of the DR Star is enable or disable and ensure that the selected DR Star is correct. 
Do you wish to continue?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 123767

Downloads: 155

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next