No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_cdp_consistency_group general

change hyper_cdp_consistency_group general


The change hyper_cdp_consistency_group general command is used to modify the name and restoration speed of a HyperCDP consistency group.


change hyper_cdp_consistency_group general cdp_consistency_group_id=? { name=? | restore_speed=? }






ID of a HyperCDP consistency group.

  • The value is an integer ranging from 0 to 99999.
  • To obtain the value, run "show hyper_cdp_consistency_group general".


New name of a HyperCDP consistency group.

The value contains 1 to 31 characters including letters, digits, hyphens (-), underscores (_), and periods (.).


Restoration speed.

The value can be:

  • "Low": indicates the low speed.
  • "Middle": indicates the medium speed.
  • "High": indicates the high speed.
  • "Highest": indicates the highest speed.

The default value is "Middle".



Usage Guidelines

The new name of a HyperCDP consistency group must be different from the names of all existing HyperCDP consistency groups.


Change the name of HyperCDP consistency group "1" to "cdpCgName" and the restoration speed to "High".

admin:/>change hyper_cdp_consistency_group general cdp_consistency_group_id=1 name=cdpCgName restore_speed=High 
WARNING: You are about to modify the rate of restoring the HyperCDP consistency group to "High" or "Highest". This operation may cause heavy service pressure and decrease the read/write performance of the host. 
Suggestion: Perform this operation during off-peak hours. 
Have you read warning message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 123908

Downloads: 155

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next