No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Command Line Completion

Command Line Completion

On the command line interface (CLI), you can either press the Tab or space key to complete a command line in stages.

NOTE:

Though both keys can be used to complete the operating segment of a command line, they imply a difference. Pressing the Tab key completes the operating segment while displaying all the possible values for the segment, whereas pressing the space key simply completes the operating segment. The following example is based on using the Tab key.

  • Press Tab once to display the available starting segments of a command line.
    admin:/>//Press Tab. 
            ^ 
    add                 change            create               
    delete              exit                export               
    help                import              poweroff             
    poweron             reboot              remove               
    scan                show                swap 
  • After the starting segment is determined and completed, press Tab once to display the available adjacent segments of the starting segment.
    admin:/>add//Press Tab. 
    cache_partition      clone                consistency_group     
    disk_domain          host                 host_group            
    lun_copy             lun_group            mapping_view          
    notification         port                 port_group            
    remote_device        security_rule        smartqos_policy       
    snmp                 storage_pool 
  • When part of a segment has been typed and its intact form can be determined by the CLI, pressing Tab once completes the segment while displaying available adjacent segments.
    admin:/>add po//Press Tab.
    admin:/>add port 
    port               port_group     
  • When an intact command line has been typed, pressing Tab responds you with a message stating that the command line can be executed. In this condition, pressing Enter executes the command line.
    admin:/>add port ipv4_route eth_port_id=0 type=net target_ip=192.168.3.0 mask=255.255.255.0 gateway=10.0.0.1//Press Tab. 
    Command is executable now.
Translation
Download
Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 115290

Downloads: 134

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next