No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_metro_consistency_group priority

change hyper_metro_consistency_group priority


The change hyper_metro_consistency_group priority command is used to change the priority of the primary and secondary devices of a HyperMetro consistency group.


change hyper_metro_consistency_group priority consistency_group_id=?






ID of the HyperMetro consistency group.

Run the "show hyper_metro_consistency_group general" command without parameters to obtain the value.



Usage Guidelines



Swap the priority of the two sites of each pair in consistency group "1".

admin:/>change hyper_metro_consistency_group priority consistency_group_id=1 
CAUTION: You are about to execute a preferred site switchover. This operation will modify the arbitration priority when array communication is interrupted.  
In static priority mode, if array communication is interrupted due to a preferred site switchover, the arbitration will fail.  
Suggestion: Before performing this operation, suspend the HyperMetro consistency group in static priority mode. 
Do you wish to continue?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 122602

Downloads: 151

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next