No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference for Block

OceanStor Dorado V3 Series V300R002

This document is applicable to OceanStor Dorado3000 V3, Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. Based on the CLI provided by the DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change lun_workload_type general

change lun_workload_type general


The change lun_workload_type general command is used to modify the settings of a workload type including the name, io_size and so on.


change lun_workload_type general id=? { name=? | io_size=? | dedup_enabled=? | compression_enabled=? } *






Indicates the workload type ID.

To obtain the value, press "Ctrl+A" or run "show lun_workload_type general" without parameters. The value ranges from 16 to 143.


Indicates the workload type name need to be changed into.

The value contains 1 to 31 ASCII characters,including digits, letters, underscores (_), hyphens (-), and periods (.).


Indicates the request size of the workload type.

The value is in the format of "4KB", "8KB", "16KB", "32KB", "64KB" or ">64KB".


Enable compression or not.

The value can be "yes" or "no", where

  • "yes": The compression function will be enabled.
  • "no": The compression function will not be enabled.


Enable deduplication or not.

The value can be "yes" or "no", where

  • "yes": The deduplication function will be enabled.
  • "no": The deduplication function will not be enabled.



Usage Guidelines

  • Before running this command, ensure that the selected workload type is exactly the one you want to modify its settings.
  • Before running this command (not to change names), ensure that no LUN uses the workload type..


Change the io_size of workload type "16" to "16KB".

admin:/>change lun_workload_type general id=16 io_size=16KB 
Command executed successfully.

System Response


Updated: 2019-07-16

Document ID: EDOC1100049140

Views: 123148

Downloads: 155

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next