No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionStorage OBS 7.0 Hardware Installation Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting a Power Cable for a TaiShan 200 (Model 2280) 12-Slot Node

Connecting a Power Cable for a TaiShan 200 (Model 2280) 12-Slot Node

This section describes how to install a power cable for a TaiShan 200 (Model 2280) 12-slot node to provide power for the storage node.


  • A PDU for the Huawei cabinet or a power distribution device for the third-party cabinet has been prepared.
  • All required tools have been prepared, including Phillips screwdrivers, cable ties, diagonal pliers, and ESD gloves or an ESD wrist strap.
  • A TaiShan 200 (Model 2280) 12-slot node has been installed.


TaiShan 200 (Model 2280) 12-slot nodes are applicable to FusionStorage OBS 7.0.1 and later versions.


  1. Wear an ESD wrist strap or ESD gloves.
  2. Insert one end of an AC power cable into the cable connector on the AC power module of the node, as shown in Figure 9-9.

    Figure 9-9 Connecting an AC power cable

  3. Use a velcro strap to bundle the power cable onto the handle of the power module.
  4. Connect the other end of the power cable to the power port of the immediately adjacent PDU and then lock it up, as shown in Figure 9-10.

    To ensure that devices can operate stably, connect power cables on a device supplied by two power modules to separate PDUs.

    Figure 9-10 Connecting a power cable to a PDU port

  5. Arrange and bind power cables.
Updated: 2020-01-03

Document ID: EDOC1100051333

Views: 25086

Downloads: 32

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next