No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage OBS 7.0 Hardware Installation Guide 06

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Attaching Labels

Attaching Labels

This section describes different methods of attaching labels.

Attaching PGND and Power Cable Labels

First attach a label to the sign plate of the cable tie (only to one side). Then, bind the cable tie to the position 20 mm from the connector, as shown in Figure 14-99.

NOTE:
  • Attach the label to the rectangular recess on the sign plate. Which side the label is attached to is not specified (determined by a customer) but must be unified.
  • The distance between a label and a connector can be adjusted but must be unified.
  • When cables are routed vertically, their labels face the right side; when routed horizontally, labels face upwards.
Figure 14-99 Binding of a sign plate to a power cable

Attaching Labels to Power Cables Inside a Cabinet

Attach the label to the place 20 mm from the power cable connector, as shown in Figure 14-100.

NOTE:
  • Do not attach a label to a bending part or a place where the label may affect cable installation.
  • The distance between a label and a connector can be adjusted but must be unified.
  • When cables are routed vertically, their labels face the right side; when routed horizontally, labels face upwards.
Figure 14-100 Attaching a label to an intra-cabinet power cable

Attaching Signal Cable Labels

Attach the label to the place 20 mm from the signal cable connector and fold the label, as shown in Figure 14-101 and Figure 14-102.

NOTE:
  • Do not attach a label to a bending part or a place where the label may affect cable installation.
  • The distance between a label and a connector can be adjusted but must be unified.
  • When cables are routed vertically, their labels face the right side; when routed horizontally, labels face upwards.
Figure 14-101 Attaching a label to a signal cable (1)
Figure 14-102 Attaching a label to a signal cable (2)
Translation
Download
Updated: 2019-07-17

Document ID: EDOC1100051333

Views: 16966

Downloads: 22

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next