No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


HUAWEI Bar 500 V600R019C00 Maintenance Guide

Describes how to maintain, and troubleshoot the Videoconferencing Endpoint.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Importing and Exporting Settings

Importing and Exporting Settings

You can configure endpoints in batches by importing the configuration file on the web interface (exporting supported also) or from a USB device.

Importing and Exporting Settings on the Web Interface

You can import or export settings on the endpoint web interface to a configuration file. After your endpoint is restored to its default settings, you can import previously exported settings from the configuration file.

Keep the configuration file safe to prevent disclosure of personal information.

  1. Choose Maintenance > Configuration Management.

    The Configuration Management page is displayed.

  2. Click Import to import or Export to export system settings.

    The web administrator password is required when you import the configuration file. After the configuration file is imported successfully, the endpoint automatically restarts for the configuration file to take effect.


    When exporting a configuration file, save the configuration file as an .xml file or do not specify a file format so that later the configuration file can be imported to the endpoint.

Importing Settings on the USB Device

  1. Use the USB configuration tool to import the configuration file to a USB device.
  2. Insert the USB device into the endpoint's USB port.
  3. Enter the administrator password of the Touch as prompted. The endpoint loads the configuration immediately.

    The endpoint restarts automatically.


    If no administrator password is set for the Touch, the password for authenticating the imported configuration file is 12345678. If you have specified an administrator password for the Touch, the configuration file authentication password must be the same as the administrator password. If they are different, the import will fail.

  4. After the restart is complete, remove the USB device.
Updated: 2019-06-25

Document ID: EDOC1100054964

Views: 8249

Downloads: 9

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next