No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Running Multicast Services in a Multicast Multi-topology Instance

Verifying the Configuration of Running Multicast Services in a Multicast Multi-topology Instance

After configuring multicast multi-topologies for multicast services, verify information about the current topology of the multicast network.

Prerequisites

Multicast multi-topologies have been configured.

Procedure

  • Run the display multicast rpf-info source-address [ group-address ] [ rpt | spt ] [ verbose ] command to check the current topology of the multicast network.

Example

Run the display multicast rpf-info source-address verbose command to view the topology used by the RPF route to the multicast source 10.110.1.2.

<HUAWEI> display multicast rpf-info 10.110.1.2 verbose
 VPN-Instance: public net
 RPF information about source: 10.110.1.2
     RPF used topology: red
     RPF interface: GigabitEthernet1/0/1, RPF neighbor: 192.168.2.1
     Referenced route/mask: 10.110.1.0/24
     Referenced route type: unicast
     Route selection rule: preference-preferred
     Load splitting rule: disabled
 Total route information about source 10.110.1.2 
     Destination/Mask   Proto   Pre Cost   NextHop         Interface
     10.110.1.0/24      unicast 15  10     192.168.2.1     GigabitEthernet1/0/0  

The command output shows that the RPF route to the multicast source 10.110.1.2 uses the topology instance red.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40731

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next