No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Loopback Interface as an RP

Configuring a Loopback Interface as an RP

You can configure a loopback interface as either a static Rendezvous Point (RP) or a Candidate-Rendezvous Point (C-RP). To configure a static RP, perform the configuration on all the routers in the PIM-SM domain; to configure a C-RP, perform the configuration only on the routers where Anycast-RP is to be configured.

Procedure

  • Configure a static RP.
    1. Run system-view

      The system view is displayed.

    2. Run pim [ vpn-instance vpn-instance-name ]

      The PIM view is displayed.

    3. Run static-rp rp-address

      The loopback interface address is configured as a static RP address.

    4. Run commit

      The configuration is committed.

  • Configure a C-RP.

    Before configuring a C-RP, configure a Candidate-BootStrap Router (C-BSR) and a BSR boundary. The C-BSR address must be different from the C-RP address.

    1. Run system-view

      The system view is displayed.

    2. Run pim [ vpn-instance vpn-instance-name ]

      The PIM view is displayed.

    3. Run c-rp loopback interface-number

      The loopback interface address is configured as a C-RP address.

    4. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 42739

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next