No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MLD SSM Mapping

Configuring MLD SSM Mapping

To allow an MLDv1 host to use the Source-Specific Multicast (SSM) service, configure SSM mapping on a multicast router.

Usage Scenario

If a multicast router runs MLDv2 but its connected user hosts have to run MLDv1, configure SSM mapping on the router, so the multicast router also provides the SSM service for the hosts that run MLDv1.

Pre-configuration Tasks

Before configuring MLD SSM mapping, complete the following tasks:

Configuration Procedures

Figure 10-2 Flowchart for configuring MLD SSM mapping
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 43968

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next