No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Specifying the Source Address for Sending Register Messages

Specifying the Source Address for Sending Register Messages

Specify the source address for sending Register messages on all devices that may become source's Designated routers (DRs). In this manner, registration errors will not occur due to repeated IP addresses on the network or filtered IP addresses.

Context

Generally, the source address for sending Register messages is the IP address of the interface connecting the source's DR to the multicast source. An error occurs if the source address for sending Register messages is not unique for the Rendezvous Point (RP) on the network or has been filtered out. To solve the problem, specify a proper interface IP address as the source address for sending Register messages.

Perform the following steps on the PIM-SM-enabled router:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run pim [ vpn-instance vpn-instance-name ]

    The PIM view is displayed.

  3. Run register-source interface-type interface-number

    The source address for sending Register messages from the source's DR is specified.

    You are advised to specify the IP address of the loopback interface as the source address for sending Register messages from the source's DR.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40551

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next