No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PIM

Configuring PIM

Configure PIM for a VPN, so that multicast VPN routing tables can be created to guide multicast data forwarding.


NG MVPN uses PIM as the multicast routing protocol. Configure PIM-SM on interfaces to allow devices to set up PIM neighbor relationships and create multicast VPN routing tables.

Perform the following steps on PEs' interfaces bound to VPN instances and on CEs' interfaces.


  1. Run system-view

    The system view is displayed.

  2. Run multicast routing-enable

    Multicast routing is enabled.

  3. Run interface interface-type interface-number

    The interface view is displayed.

  4. Run pim sm

    PIM-SM is enabled.

  5. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44070

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next