No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Unified Transmission of Report/Done Messages

Configuring Unified Transmission of Report/Done Messages

Unified transmission of Report/Done messages enables a Layer 2 device to summarize Report/Done messages of downstream hosts and send them to an upstream device in a unified manner. This saves bandwidth resources on the network side.

Context

Redundant MLD messages waste network-side bandwidth resources, especially when there are a large number of hosts on a network. To resolve this issue, configure unified transmission of Report/Done messages, allowing the device to respond only one MLD Report message to an MLD Query message of a group sent by the upstream device, regardless of the number of interfaces that have joined the same multicast group.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Perform either of the following operations based on the VLAN or VPLS networking scenario:

    • Run the vlan vlan-id command to enter the VLAN view.
    • Run the vsi vsi-name [ static ] command to enter the VSI view.

  3. Run mld-snooping proxy

    MLD snooping proxy is enabled.

    MLD snooping proxy provides two functions: querier and unified message transmission. With the querier function, a Layer 2 device can send MLD Query messages. With the unified message transmission function, a Layer 2 device can receive MLD Report and Down messages from downstream devices and send them in a unified manner.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40736

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next