No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MBGP Routing Policies

Configuring MBGP Routing Policies

MBGP routing policies can be configured to flexibly control the sending and receiving of routes.

Usage Scenario

Routing policies can be used to set or re-set MBGP route attributes by using some predefined conditions, which provides a flexible and effective method to control MBGP route selection. The sending and receiving of routes can be flexibly controlled by applying MBGP routing policies.

Pre-configuration Tasks

Before configuring MBGP routing policies, configure an MBGP peer.

Configuration Procedures

Perform one or more of the following configurations as required.

Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 39519

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next