No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Reflection on an ABR

Configuring Route Reflection on an ABR

Route reflection on an ABR is used to reflect the VPNv4 routes advertised by the PE to other devices in the same AS.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp as-number

    The BGP view is displayed.

  3. Run ipv4-family unicast

    The unicast IPv4 address family view is displayed.

  4. Run peer peer-ipv4-address reflect-client

    The ABR is configured as a route reflector. If you need to configure multiple devices as clients, repeatedly run this command.

  5. Run peer peer-ipv4-address next-hop-local

    The IP address of the ABR is set as the next hop of routes when the ABR advertises routes to IBGP peers.

  6. Run undo policy vpn-target

    The function to filter unicast routes based on VPN targets is disabled.

  7. Run quit

    The BGP view is displayed.

  8. Run ipv4-family mvpn

    The BGP—MVPN address family view is displayed.

  9. Run reflect change-path-attribute

    The RR can modify route attributes of BGP routes.

  10. Run peer peer-ipv4-address reflect-client

    The ABR is configured as a route reflector. If you need to configure multiple devices as clients, repeatedly run this command.

  11. Run undo policy vpn-target

    The function to filter MVPN routes based on VPN targets is disabled.

  12. Run quit

    The BGP view is displayed.

  13. Run ipv4-family vpnv4

    The BGP—VPNv4 address family view is displayed.

  14. Run peer peer-ipv4-address reflect-client

    The ABR is configured as a route reflector. If you need to configure multiple devices as clients, repeatedly run this command.

  15. Run peer peer-ipv4-address next-hop-local

    The IP address of the ABR is set as the next hop of routes when the ABR advertises routes to IBGP peers.

  16. Run undo policy vpn-target

    The function to filter VPNv4 routes based on VPN targets is disabled.

  17. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 38989

Downloads: 96

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next