No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PIM-SSM

Configuring PIM-SSM

The PIM-SSM model provides the source-specific transmission service for receivers. In PIM-SSM, a dedicated multicast forwarding path is set up directly between a source and a receiver.

Usage Scenario

PIM-SSM adopts partial PIM-SM technologies. In Protocol Independent Multicast-Source-Specific Multicast (PIM-SSM), there is no need for Rendezvous Point (RP) mapping, rendezvous point tree (RPT) construction, or multicast source registration. In PIM-SSM, the Designated router (DR) is valid only on the shared network segment connected with group members. After learning the requirements of users, the receiver's DR sends a Join message to the multicast source. The Join message is sent upstream hop by hop and (S, G) entries are created correspondingly. As a result, a shortest path tree (SPT) from the router directly connected to the source to the receiver's DR is set up.

To implement PIM-SSM, the following conditions must be met:

  • The multicast group that users join is in the SSM group address range.

  • Users specify the source when joining a multicast group.

  • Devices run PIM-SM.

A network can adopt both the PIM-SM and PIM-SSM models. To implement PIM-SSM, first complete PIM-SM configurations, including RP configurations. Then, adjust the SSM group address range as needed. If the groups that hosts want to join are not in the SSM group address range, PIM-SM is adopted to forward multicast data.

Pre-configuration Tasks

Before configuring PIM-SSM, configure a unicast routing protocol to ensure that unicast routes are reachable.

Configuration Procedures

Figure 4-5 Flowchart for configuring PIM-SSM
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 39346

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next