No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of IPv6 PIM

Monitoring the Running Status of IPv6 PIM

You can monitor the IPv6 PIM running status by checking unicast routes, BootStrap routers (BSRs), and Rendezvous Points (RPs) used by IPv6 PIM, statistics about PIM control messages, and information about PIM neighbors and PIM routing tables.

Context

You can run the following commands in any view to check the IPv6 PIM running status.

Procedure

  • Run the display pim ipv6 claimed-route [ source-address ] command to check unicast routes used by IPv6 PIM.
  • Run the display pim ipv6 bsr-info command to check information about a BSR in an IPv6 PIM-SM domain.
  • Run the display pim ipv6 control-message counters message-type { probe | register | register-stop | crp } or display pim ipv6 control-message counters [ message-type { assert | hello | join-prune | bsr } | interface interface-type interface-number ] * command to check statistics about IPv6 PIM control messages.
  • Run the display pim ipv6 interface [ interface-type interface-number ] [ verbose ] command to check IPv6 PIM interfaces.
  • Run the display pim ipv6 neighbor [ ipv6-link-local-address | interface interface-type interface-number | verbose ] * command to check IPv6 PIM neighbors.
  • Run the display pim ipv6 routing-table [ ipv6-source-address [ mask mask-length ] | ipv6-group-address [ mask mask-length ] | incoming-interface { interface-type interface-number | register } | outgoing-interface { include | exclude | match } { interface-type interface-number | register | none } | mode { sm | ssm } | flags flag-value | fsm ] * [ outgoing-interface-number [ number ] ] command to check the IPv6 PIM routing table.
  • Run the display pim ipv6 rp-info [ ipv6-group-address ] command to check information about an RP in an IPv6 PIM-SM domain.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40762

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next