No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Global Anycast-RP

Configuring Global Anycast-RP

If Anycast-RP is configured on some devices in a PIM-SM domain, configure the address of the Rendezvous Point (RP) elected in the PIM-SM domain as the Anycast-RP address.



Either static or dynamic RPs can be used. Configuring RPs on loopback interfaces is recommended. On the routers that require Anycast-RP, configure the same RP address.


  1. Run system-view

    The system view is displayed.

  2. Run pim [ vpn-instance vpn-instance-name ]

    The PIM view is displayed.

  3. Run anycast-rp rp-address

    An Anycast-RP is configured, and the Anycast-RP view is displayed.


    The Anycast-RP address must be the same as that of the elected RP.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40039

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next