No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a BSR Boundary (IPv6)

Configuring a BSR Boundary (IPv6)

Before configuring IPv6 PIM-SM inter-domain multicast, configure BootStrap router (BSR) boundaries to divide a multicast network into different PIM-SM domains. Each BSR serves only the local PIM-SM domain, and routers outside the BSR boundary of a PIM-SM domain do not take part in BSR messages forwarding in the PIM-SM domain.

Usage Scenario

After a BSR boundary is configured on the interface of an edge router in an IPv6 PIM-SM domain, Bootstrap messages cannot pass through this interface. The interfaces configured with BSR boundaries divide a network into different PIM-SM domains.

BSR boundaries can also be used to isolate PIM-SM domains from the Internet.

Pre-configuration Tasks

Before configuring a BSR boundary, complete the following tasks:

  • Configure an IPv6 unicast routing protocol to ensure that IPv6 unicast routes are reachable.

  • Enable IPv6 multicast routing on all routers and enable IPv6 PIM-SM on each interface on the routers.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run pim ipv6 bsr-boundary

    A BSR boundary is configured. Bootstrap messages cannot pass through the BSR boundary.

  4. Run commit

    The configuration is committed.

Checking the Configurations

Run the display pim ipv6 bsr-info command to check information about the BSR in an IPv6 PIM-SM domain.

Follow-up Procedure

Configure a BSR RP in each IPv6 PIM-SM domain.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 39899

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next