No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RPF Routes

Configuring RPF Routes

A multicast routing protocol creates multicast routing entries based on the Reverse Path Forwarding (RPF) mechanism and then establishes an MDT.

Usage Scenario

The RPF check is a basis of multicast routing. The process of performing an RPF check is as follows:

  1. Based on the source of a packet, a router searches its unicast routing table and multicast static routing table for optimal routes.

  2. The router selects a route with the highest priority from the multiple optimal routes as an RPF route. If the inbound interface of the packet is the same as the RPF interface, the packet passes the RPF check; otherwise, the packet fails the RPF check.

    If the priorities of the optimal routes are the same, the router selects the route in the sequence of the multicast static route and unicast route.

By configuring multicast static routes, you can specify an RPF interface and an RPF neighbor for the specific source of packets.

In choosing an upstream interface, a multicast router prefers the route with the highest next-hop address by default. If there are multiple equal-cost unicast routes, you can configure different policies of implementing multicast load splitting among these routes and designating different upstream interfaces for different multicast entries. In this manner, the transmission of multiple multicast data flows over a network is optimized.

Pre-configuration Tasks

Before configuring RPF routes, complete the following tasks:

  • Configure a unicast routing protocol to ensure that unicast routes are reachable.

  • Configure basic multicast functions.

Configuration Procedures

Perform one or more of the following configurations as required.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44286

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next