No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Specifying the Source Address for Sending Register Messages (IPv6)

Specifying the Source Address for Sending Register Messages (IPv6)

Specify the source address for sending Register messages on all devices that may become source's Designated routers (DRs). In this manner, registration errors will not occur due to repeated IP addresses on the network or filtered IPv6 addresses.

Context

Generally, the source IPv6 address for sending Register messages is the IPv6 address of the interface connecting the source's DR to the multicast source. An error occurs if the source IPv6 address for sending Register messages is not unique for the RP on the network or has been filtered out. To solve the problem, specify a proper IPv6 global unicast address as the source address for sending Register messages (IPv6).

Perform the following steps on the IPv6 PIM-SM-enabled router:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run pim-ipv6

    The IPv6 PIM view is displayed.

  3. Run register-source ipv6-address

    The source IPv6 address for sending Register messages from the source's DR is specified.

    You are advised to specify the IPv6 address of the loopback interface as the source IPv6 address for sending Register messages from the source's DR.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 39049

Downloads: 96

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next