No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of an IPv4 Multicast VPN

Monitoring the Running Status of an IPv4 Multicast VPN

During routine maintenance of an IPv4 multicast VPN, you can run the display commands in any view to obtain the running status of the IPv4 multicast VPN.

Context

You can run the following commands in any view to check the running status of an IPv4 multicast VPN.

Procedure

  • Run the display multicast-domain vpn-instance vpn-instance-name share-group [ local ] command in any view to check Share-Group information about a specified VPN instance in a multicast domain (MD).
  • Run the following commands in any view to check switch-group information received by a specified VPN instance in an MD.

    • display multicast-domain vpn-instance vpn-instance-name switch-group receive brief

    • display multicast-domain vpn-instance vpn-instance-name switch-group receive [ active | group group-address | sender source-address | vpn-source-address [ mask { source-mask-length | source-mask } ] | vpn-group-address [ mask { group-mask-length | group-mask } ] ] *

  • Run the display multicast-domain vpn-instance vpn-instance-name switch-group send [ group group-address | reuse interval | vpn-source-address [ mask { source-mask-length | source-mask } ] | vpn-group-address [ mask { group-mask-length | group-mask } ] ] * command in any view to check the switch-group information sent by a specified VPN instance in an MD.
  • Run the display multicast-domain { vpn-instance vpn-instance-name | all-instance } control-message counters command in any view to check the statistics about sent and received MDT switch messages in a specified VPN instance or all VPN instances.
  • Run the display multicast-domain { vpn-instance vpn-instance-name | all-instance } invalid-packet command in any view to check the statistics about invalid MDT switch messages received by a device.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 38987

Downloads: 96

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next