No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the TTL Threshold for Forwarding an SA Message Containing a Multicast Data Packet

(Optional) Setting the TTL Threshold for Forwarding an SA Message Containing a Multicast Data Packet

After receiving a source active (SA) message encapsulated with a multicast data packet, an MSDP peer forwards the SA message to a specified remote MSDP peer only when the TTL value of the multicast packet is greater than the configured TTL threshold.

Context

Perform the following steps on the router configured with an MSDP peer:

NOTE:

If the configuration is not performed, default parameter values are used.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run msdp [ vpn-instance vpn-instance-name ]

    The MSDP view is displayed.

  3. Run peer peer-address minimum-ttl ttl

    A TTL threshold is set for multicast data packets.

    After receiving an SA message containing a multicast data packet, an MSDP peer forwards the SA message to a specified remote MSDP peer only when the TTL value of the multicast packet is greater than the configured TTL threshold.

    The parameter meanings as follows:

    • peer-address: specifies the IP address of a remote MSDP peer.

    • ttl: specifies the value of the TTL threshold. The default value is 0.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 42667

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next