No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Layer 2 Multicast Configuration

Layer 2 Multicast Configuration

This chapter describes how to configure Layer 2 multicast and provides configuration examples. Layer 2 multicast is used to transmit multicast data at the data link layer. It uses Internet Group Management Protocol (IGMP) snooping to listen to IGMP messages exchanged between an upstream device and hosts attached to the device and then use these messages to create a Layer 2 multicast forwarding table, achieving on-demand multicast data transmission at the data link layer. If both Layer 2 multicast and Layer 3 multicast are configured, ensure the consistency between Layer 2 multicast configurations and Layer 3 multicast configurations. If Layer 2 multicast configurations are inconsistent with Layer 3 multicast configurations, Layer 2 multicast will inherit Layer 3 multicast configurations. As a result, the Layer 2 multicast configurations will become unavailable.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 43358

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next