No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting Other PIM Parameters

Adjusting Other PIM Parameters

You can adjust neighbor parameters, Designated router (DR) parameters, and forwarding parameters based on actual networking situations.

Usage Scenario

A router can work normally with default control parameter configurations. If the default configurations do not fit your requirements, you can reconfigure the parameters, including neighbor parameters, DR parameters, and forwarding parameters.

NOTE:

If there is no special requirement, default parameter values are recommended.

Pre-configuration Tasks

Before adjusting other PIM parameters, complete the following tasks:

Configuration Procedures

Perform one or more of the following configurations as required.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40784

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next