No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Directing Multicast Traffic into a P2MP TE Tunnel

Directing Multicast Traffic into a P2MP TE Tunnel

Multicast data traffic can be correctly forwarded over a point-to-multipoint (P2MP) traffic engineering (TE) tunnel only after being directed into the P2MP TE tunnel.


When a P2MP TE tunnel is used to carry multicast services, you do not need to deploy the Protocol Independent Multicast (PIM) on the transit nodes of the tunnel. As a result, you must direct multicast traffic on a P2MP tunnel interface of the ingress on the P2MP TE tunnel into the P2MP TE tunnel.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel tunnel-number

    The tunnel interface view is displayed.

  3. Run igmp static-group group-address [ inc-step-mask { group-mask | group-mask-length } number group-number ] [ source source-address ]

    The interface is configured to statically join an IGMP group.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 43490

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next