No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Layer 2 Multicast CAC Configuration

Verifying the Layer 2 Multicast CAC Configuration

After configuring Layer 2 multicast CAC, verify the configuration, including Layer 2 multicast entry and bandwidth limits of global and VSI channels.

Prerequisites

Layer 2 multicast CAC has been configured.

Procedure

  • Run the display l2-multicast-channel limit [ configuration | statistics ] vsi [ vsi-name [ interface interface-type interface-number | remote-peer ip-address [ negotiation-vc-id vc-id ] ] ] command to check the configured Layer 2 multicast entry and bandwidth limits, as well as the entry and bandwidth statistics, of VSIs or sub-interfaces.
  • Run the display l2-multicast-channel [ vsi vsi-name | global ] [ channel channel-name ] command to check information about global or VSI channels.

Example

Run the display l2-multicast-channel limit command to view the configured Layer 2 multicast entry and bandwidth limits, as well as the entry and bandwidth statistics.

<HUAWEI> display l2-multicast-channel limit
L2-multicast limit information, The unit of bandwidth is Kbits/sec
------------------------------------------------------------------------------
                                               ConfigEntries  ConfigBandwidth
                                               CurrentEntries CurrentBandwidth
------------------------------------------------------------------------------
interface Eth-Trunk1.1 dot1q vid 11 limit information:
------------------------------------------------------------------------------
    Bandwidth limit mode: per-trunk-member
------------------------------------------------------------------------------
                                               ----           1000
                                               ----           0
interface Eth-Trunk1.1 dot1q vid 11 limit information:
------------------------------------------------------------------------------
                                       tv1     ----           2500
                                               ----           0

Run the display l2-multicast-channel command to view information about global or VSI channels.

<HUAWEI> display l2-multicast-channel
Channel information on VSI vsi1
 ChannelName                    Group/Mask         Source/Mask        Bandwidth
-------------------------------------------------------------------------------
 tv1                            225.0.0.0/24       *                  10
------------------------------------------------------------------------------- 
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44103

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next