No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an MD VPN

Configuring an MD VPN

The NE40E uses multicast domain (MD) to implement multicast VPN in Any-Source Multicast (ASM) mode, and in this situation multicast data of private networks can be transmitted over public networks.

Usage Scenario

MD VPN only supports IP multicast in ASM mode on the public network. PIM tunnels are set up on the public network to transmit multicast data between sites in a VPN.

Before transmitting multicast data in a VPN, ensure that this VPN functions properly. To allow a PE to receive data from multiple VPNs, configure a public network instance and multiple VPN instances on the PE. The public network instance is responsible for the communication with the P, and the VPN instances are responsible for the communication with their connected Customer Edges (CEs).

A share-MDT needs to be set up to forward multicast packets in an MD VPN. Or, a special switch-multicast distribution tree (MDT) can be set up to switch multicast data of private networks flowing to the public network from the share-MDT to the switch-MDT for transmission. Multicast data can therefore be transmitted on demand, and the pressure on Provider Edges (PEs) is reduced.

Pre-configuration Tasks

Before configuring an MD VPN, complete the following tasks:

  • Configure a unicast routing protocol to ensure that unicast routes are reachable.

  • Configure BGP/MPLS VPN.

  • Configure multicast on the public network.

Configuration Procedures

Figure 8-2 Flowchart for configuring an MD VPN
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 43214

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next