No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Static Layer 2 Multicast Configuration

Verifying the Static Layer 2 Multicast Configuration

After configuring static Layer 2 multicast, verify the port information table and Layer 2 multicast forwarding table to verify that the static Layer 2 multicast configurations are complete.

Prerequisites

The static Layer 2 multicast configurations are complete.

Procedure

  • Run the display igmp-snooping router-port { vlan vlan-id | vsi vsi-name } command to check router port information.
  • Run the display igmp-snooping port-info [ vlan vlan-id [ group-address group-address ] | vsi vsi-name [ group-address group-address ] ] [ verbose ] command to check static member port information.

Example

Run the display igmp-snooping router-port command to view the static router port configurations in VLAN 10.

<HUAWEI> display igmp-snooping router-port vlan 10
 Port Name                         UpTime           Expires         Flags
 ----------------------------------------------------------------------------
 VLAN 10, 1 router-port(s)
 GigabitEthernet2/0/1              00:00:17         --              STATIC 

Run the display igmp-snooping router-port command to view the static router port configurations in VSI v123.

<HUAWEI> display igmp-snooping router-port vsi v123
 Port Name                       UpTime        Expires       Flags
 ---------------------------------------------------------------------
 VSI v123, 1 router-port(s)
 PW(1.1.1.1/123)                 00:05:16      --            STATIC  

Run the display igmp-snooping port-info command to determine whether the static member port configurations will take effect. S indicates that an interface is configured as a static member port. For example:

<HUAWEI> display igmp-snooping port-info
 -----------------------------------------------------------------------------------
  Flag: S:Static     D:Dynamic     M:Ssm-mapping
        A:Active     P:Protocol    F:Fast-channel                                
                    (Source, Group)  Port                                      Flag
 -----------------------------------------------------------------------
 VLAN 10, 3 Entry(s)
               (10.1.1.2, 224.1.1.1)  GE1/0/1                        S-- 
                                                1 port(s)
               (10.1.1.3, 224.1.1.1)  GE1/0/1                        S-- 
                                                1 port(s)
               (10.1.1.4, 224.1.1.1)  GE1/0/1                        S--
                                                1 port(s)
 ----------------------------------------------------------------------- 
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 39143

Downloads: 96

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next