No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of BFD for IPv6 PIM

Verifying the Configuration of BFD for IPv6 PIM

After configuring BFD for IPv6 PIM, verify statistics about and configurations of BFD for IPv6 PIM sessions.

Prerequisites

All the configurations of BFD for IPv6 PIM are complete.

Procedure

  • Run the display pim ipv6 bfd session statistics command to check information of BFD sessions.
  • Run the display pim ipv6 bfd session [ interface interface-type interface-number | neighbor ipv6-link-local-address ] * command to check configurations of BFD sessions.

Example

  • Run the display pim ipv6 bfd session statistics command. The command output shows statistics about BFD sessions in the public network instance.

    <HUAWEI> display pim ipv6 bfd session statistics
     VPN-Instance: public net
      Total 1 PIM BFD session in this instance.
    
       Total 1 PIM BFD session up.
       Total 0 PIM BFD session down.
    

    The command output shows that one BFD session is set up in the public network instance, one BFD session is in the Up state, and no BFD session is in the Down state.

  • Run the display pim ipv6 bfd session interface interface-type interface-number command. The command output shows configurations of BFD sessions on a specified interface in the public network instance.

    <HUAWEI> display pim ipv6 bfd session interface gigabitethernet 1/0/0
     VPN-Instance: public net
    
     GigabitEthernet1/0/0 (FE80::7): Total 1 BFD session Created
    
    
     Neighbor      ActTx(ms)    ActRx(ms)   ActMulti    Local/Remote  State
     FE80::6       100          100         4           8211/8214     Up

    The command output shows that the PIM neighbor that sets up a BFD session with GE 1/0/0 is of the link-local address FE80::6 and the BFD session is in the Up state.

    The actual sending interval and receiving interval of BFD packets are both 100 ms and the actual detection multiplier is 4.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 42658

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next