No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling State-Refresh

(Optional) Disabling State-Refresh

This section describes how to disable State-Refresh. State-Refresh can be disabled if all clients receive multicast data. When State-Refresh is disabled on an interface, the interface does not forward State-Refresh messages.

Context

The PIM-DM status is refreshed based on the State-Refresh messages periodically sent on the network. A router in the Prune state resets the Prune status timer upon the receipt of a State-Refresh message. This implementation prevents the downstream interfaces from forwarding data when the timer expires.

When State-Refresh is disabled, interfaces start to forward multicast data after the Prune timer expires. The downstream router that rejects the data then sends Prune messages. However, this process repeats itself periodically, occupying a lot of network resources. It is advised not to disable State-Refresh, because this allows you to save network resources.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run undo pim state-refresh-capable

    State-Refresh is disabled. The interface on which this function is disabled does not forward State-Refresh messages.

    By default, State-Refresh is enabled.

    NOTE:
    You can run the pim state-refresh-capable command to re-enable State-Refresh on interfaces.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40652

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next