No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 PIM-SSM

Configuring IPv6 PIM-SSM

Protocol Independent Multicast-Source-Specific Multicast (PIM-SSM) enables a user to specify a multicast source that will send data to a desired group. PIM-SSM is implemented based on some PIM-SM technologies. In PIM-SSM, no Rendezvous Point (RP) needs to be maintained and a dedicated multicast forwarding path is set up between a receiver and a specified multicast source.

Usage Scenario

PIM-SSM uses only some PIM-SM technologies. In PIM-SSM, it is unnecessary to maintain an RP, build an rendezvous point tree (RPT), or register a multicast source. The Designated router (DR) is valid only on a shared network segment connected to group members. Based on users' requirements, the receiver's DR sends a Join message towards the multicast source. The Join message is transmitted upstream hop by hop, and an (S, G) entry is created on each hop. An SPT is built from the router directly connected to the multicast source to the receiver's DR.

To implement PIM-SSM, the following conditions must be met:

  • The IPv6 multicast group that users join is in the SSM group address range.

  • Users specify the source when joining an IPv6 multicast group.

  • routers run PIM-SM.

A network can adopt both the PIM-SM and PIM-SSM models. After configuring IPv6 PIM-SM on the network, you can adjust the SSM group address range as needed. If an IPv6 multicast group that a user wants to join is not in the SSM group address range, PIM-SM is adopted to forward IPv6 multicast packets.

Pre-configuration Tasks

Before configuring IPv6 PIM-SSM, configure an IPv6 unicast routing protocol to ensure that IPv6 unicast routes are reachable.

Configuration Procedures

Figure 11-2 Flowchart for configuring IPv6 PIM-SSM
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 43816

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next