No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling BFD for IPv6 PIM

Enabling BFD for IPv6 PIM

BFD detection responds to the fault occurring on the current Designated router (DR) or Assert winner on the shared network segment and instructs the PIM to trigger a new DR or Assert election. This shortens the period during which multicast data transmission is discontinued.

Context

Perform the following steps on the routers that have set up a PIM neighbor relationship:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

    NOTE:

    PIM BFD applies only to non-broadcast multiple access (NBMA) and broadcast interfaces, not Point-to-point (P2P) interfaces.

  3. Run pim ipv6 sm

    IPv6 PIM-SM is enabled.

  4. Run pim ipv6 bfd enable

    IPv6 BFD for PIM is enabled.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 42740

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next