No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Global Layer 2 Multicast CAC

Configuring Global Layer 2 Multicast CAC

Global Layer 2 multicast CAC configurations are performed to limit the global multicast bandwidth.

Context

Global Layer 2 multicast CAC configurations take effect on an entire device. After Layer 2 multicast CAC is configured globally, the bandwidth of each multicast group (including multicast groups in VSIs) is limited.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run l2-multicast-channel

    The global channel view is displayed.

  3. (Optional) Run unspecified-channel deny

    The device is enabled to filter out multicast data for groups undefined in a global channel.

    After this command is run, the device permits only multicast data for groups defined in a global channel and denies all multicast data for groups undefined in a global channel.

  4. Run channel channel-name type { asm | ssm }

    A global channel is created.

  5. Run group group-address { group-mask-length | group-mask } [ per-bandwidth bandwidth ]

    Multicast groups are specified for the channel. If per-bandwidth bandwidth is set, the bandwidth is limited to a specific value for each multicast group in the global channel. If this parameter is not set, the bandwidth is not limited for any multicast group in the global channel.

  6. Run commit

    The configuration is committed.

  7. Run quit

    Exit from the channel view.

  8. Run quit

    Exit from the global channel view.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40725

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next