No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPV6 PIM

Configuring IPV6 PIM

Configuring IPv6 PIM on a VPN allows a VPN multicast routing table to be established to guide multicast traffic forwarding.

Context

IPv6 NG MVPNs also use IPv6 PIM as the multicast routing protocol on the user network. PIM neighbor relationships can be established between devices only after PIM-SM is enabled on interfaces. Then a VPN multicast routing table can be established to guide multicast traffic forwarding.

Procedure

  • Perform the following steps on the PE interfaces bound to a VPN instance.

    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed. The interface is bound to a VPN instance.

    3. Run pim ipv6 sm

      PIM-SM is enabled.

    4. Run commit

      The configuration is committed.

  • Perform the following steps on the CE.

    1. Run system-view

      The system view is displayed.

    2. Run multicast ipv6 routing-enable

      Multicast routing is enabled.

    3. Run interface interface-type interface-number

      The interface view is displayed.

    4. Run pim ipv6 sm

      PIM-SM is enabled.

    5. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44273

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next