No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static SSM Mapping

Configuring Static SSM Mapping

To allow MLDv1 hosts to use the Source-Specific Multicast (SSM) service, configure static SSM mapping by establishing mappings between multicast groups and sources.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mld

    The MLD view is displayed.

  3. Run ssm-mapping ipv6-group-address ipv6-group-mask-length ipv6-source-address

    A mapping is created between a multicast group and a multicast source.

    • ipv6-group-address ipv6-group-mask-length: specifies an MLD group address and mask, which must be in the SSM group address range.

    • ipv6-source-address: specifies an IPv6 multicast source address to be mapped to the MLD group address.

    To map a multicast group to N (an integer) sources, run the ssm-mapping command N times.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 43573

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next