No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a BSR Boundary

Configuring a BSR Boundary

Before configuring PIM inter-domain multicast, configure BootStrap router (BSR) boundaries to divide a multicast network into different PIM-SM domains. Each BSR serves only the local PIM-SM domain, and routers outside the BSR boundary of a PIM-SM domain do not take part in BSR message forwarding in this PIM-SM domain.

Usage Scenario

After a BSR boundary is configured on the interface of an edge router in a PIM-SM domain, Bootstrap messages cannot pass through this interface. The interfaces configured with BSR boundaries divide the network into different PIM-SM domains.

BSR boundaries can also be used to isolate PIM-SM domains from the Internet.

Pre-configuration Tasks

Before configuring a BSR boundary, complete the following tasks:

  • Configure a unicast routing protocol to ensure that unicast routes are reachable.

  • Enable multicast routing on all routers and enable PIM-SM on all interfaces.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run pim bsr-boundary [ incoming ]

    A BSR boundary is configured. BSR messages cannot pass through the BSR boundary.

    If incoming is specified, the local PIM-SM domain can send BSR messages to all other PIM-SM domains but cannot receive BSR messages from other PIM-SM domains.

  4. Run commit

    The configuration is committed.

Checking the Configurations

Run the display pim [ vpn-instance vpn-instance-name | all-instance ] bsr-info command to check BSR information in a PIM-SM domain.

Follow-up Procedure

  1. Configure a BSR RP for each PIM-SM domain.

  2. Set up MSDP peer relationships between RPs in PIM-SM domains and configure PIM-SM inter-domain multicast.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44267

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next