No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static SSM Mapping

Configuring Static SSM Mapping

To allow IGMPv1 or IGMPv2 hosts to use the Source-Specific Multicast (SSM) service, configure static SSM mapping by establishing mappings between multicast groups and sources.

Context

If an IGMPv1 or IGMPv2 host requests multicast data from a specific multicast source, but the host's IGMP version cannot be upgraded to IGMPv3, configure a static SSM mapping policy to map the multicast group to the multicast source.

A static SSM mapping policy can be configured in the following situations:

Interfaces in the same VPN share one SSM mapping.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run igmp [ vpn-instance vpn-instance-name ]

    The IGMP view is displayed.

  3. Run ssm-mapping group-address { mask | mask-length } source-address

    A mapping is created between a multicast group and a multicast source. To map a multicast group to N (an integer) sources, run the command N times.

    • group-address { mask | mask-length }: specifies an IGMP group address and mask, which must be in the SSM group address range.

    • source-address: specifies the address of a source to be mapped to the multicast group.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44282

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next