No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Anycast-RP Peer

Configuring an Anycast-RP Peer

When sending a PIM Register message to all Anycast-Rendezvous Point (RP) peers, the local RP needs to use the peer addresses as the destination addresses of the Register message.


The routers functioning as Anycast-RPs can be identified by the same logical address so that the RP in the PIM-SM domain is unique. However, the routers need to distinguish one another during the communication, so the Anycast-RP address cannot be used. To resolve this issue, configure Anycast-RP peers.


  1. Run system-view

    The system view is displayed.

  2. Run pim-ipv6

    The PIM-IPv6 view is displayed.

  3. Run anycast-rp rp-address

    The IPv6 Anycast-RP view is displayed.

  4. Run peer peer-address

    An Anycast-RP peer is specified.

    peer-address: specifies the address of an Anycast-RP peer.


    In a PIM-SM domain, all Anycast-RP-capable devices must be fully connected. Anycast-RP peer relationships must be configured between every two Anycast-RPs.

  5. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40087

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next