No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the IPv4 User-Side Multicast Configuration

Verifying the IPv4 User-Side Multicast Configuration

This section describes how to verify multicast group joining information of online users and statistics about IGMP messages.

Procedure

  • Run the following commands to display statistics about IGMP messages:

    • Run the display igmp statistics command to display statistics about IGMP messages.

    • Run the display igmp-snooping bas invalid-packet command to display statistics about invalid IGMP messages on broadband access server (BAS) interfaces.

  • Run the following commands to display information about users and the multicast programs they join:

    • Run the display multicast user-id command to display information about multicast programs that a specified user joins on BAS interfaces.

    • Run the display multicast group-ip command to display information about users of a specified multicast group.

    • Run the display multicast user-info command to display information about users and the multicast programs they join on a specified slot or interface.

    • Run the display igmp-snooping bas port-info command to display information about users and the multicast programs they join on a specified BAS interface.

    • Run the display igmp-snooping bas group-info command to display information about multicast groups that a specified user joins on a BAS interface.

  • Run the following command to display information about PIM entries and multicast routing entries:

    • Run the display pim routing-table command to display information about Protocol Independent Multicast (PIM) routing entries.

    • Run the display multicast routing-table command to display information about multicast routing entries.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40456

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next